Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL CRANKSHAFT POSITION SENSOR


A095436E01

NOTICE:
Make sure that the O-ring is not cracked or jammed when installing it.

  1. Apply a light coat of engine oil to the O-ring of the sensor.



    A116845E01
  1. Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 90 kgf*cm , 80 in.*lbf }

  1. Install the wire harness clamp.

  1. Install the connector clamp.

  1. Connect the sensor connector.

  1. Confirm that the wire harness of the sensor is secured to the wire harness clamp bracket through the back of the rib of the timing chain cover.



2. INSTALL GENERATOR ASSEMBLY
  1. Install the generator to the vehicle (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK FOR ENGINE OIL LEAKAGE