Home
›
ENGINE · 1AZ-FE
›
ENGINE CONTROL SYSTEM
›
CRANKSHAFT POSITION SENSOR
CRANKSHAFT POSITION SENSOR > INSPECTION
for Preparation
Click here
1. INSPECT CRANKSHAFT POSITION SENSOR
Measure the resistance of the sensor.
Standard resistance:
Tester Connection
Specified Condition
1 (NE+) - 2 (NE-)
985 to 1,600 Ω at Cold
1 (NE+) - 2 (NE-)
1,265 to 1,890 Ω at Hot
NOTICE:
Cold and Hot refers to the temperature of the sensor. Cold is from -10 to 50°C (14 to 122°F) and Hot is from 50 to 100°C (122 to 212°F).
If the result is not as specified, replace the crankshaft position sensor.