Home › ENGINE ยท 2AZ-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE GENERATOR ASSEMBLY
  1. Remove the generator assembly from the vehicle (Click here).



3. REMOVE CRANKSHAFT POSITION SENSOR


A097797E01
  1. Disconnect the sensor connector.

  1. Remove the connector clamp.

  1. Remove the wire harness from the wire harness clamp bracket.

  1. Remove the wire harness clamp.

  1. Remove the bolt and sensor.