GENERATOR > INSPECTION |
| 1. INSPECT GENERATOR BRUSH HOLDER ASSEMBLY |
![]() |
Using a vernier caliper, measure the brush length.
| 2. INSPECT GENERATOR ROTOR ASSEMBLY |
![]() |
Check the resistance.
Measure the resistance between the slip rings.
![]() |
Measure the resistance between the slip ring and rotor core.
![]() |
Check the slip ring diameter.
Using a vernier caliper, measure the slip ring diameter.
![]() |
Check the appearance.
Check that the bearing is not rough or worn.
| 3. INSPECT GENERATOR DRIVE END FRAME BEARING |
![]() |
Check that the bearing is not rough or worn.