Home › ENGINE ยท 2AZ-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY WITH CLUTCH


    A126771
  1. Remove the cap from the pulley.

    1. Using a screwdriver, puncture the center of the cap and pry it off.

      NOTICE:
      Do not reuse the cap.



    A126778E01
  1. Install SST to the pulley and vise as shown in the illustration.

    SST
    09820-63021  

  1. Mount SST (A) in a vise.



    A126779E01
  1. Turn SST (B) clockwise to loosen the pulley.

  1. Remove the pulley.



2. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A130331
  1. Remove the 3 nuts and generator rear end cover.



    A097461E01
  1. Remove the terminal insulator.



    A097462E01
  1. Remove the 2 screws and generator brush holder.



3. REMOVE GENERATOR ROTOR ASSEMBLY


    A097464E01
  1. Remove the bolt and cord clip.



    A097465E01
  1. Remove the 4 bolts.



    A122144E01
  1. Using SST, remove the coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010)

  1. Remove the washer.

  1. Remove the generator rotor.