Home › ENGINE ยท 1AZ-FE › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY


    A097468
  1. Install the washer onto the generator rectifier end frame.



    A097467E01
  1. Install the generator rotor onto the generator rectifier end frame.



    A097475E02
  1. Using a 32 mm socket wrench and press, slowly push the generator drive end frame onto the generator rectifier end frame.



    A097465E01
  1. Tighten the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



    A097464E01
  1. Install the cord clip with the bolt.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A079315E04
  1. While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.



    A097463E02
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull the pin out of the generator brush holder.



    A097461E01
  1. Install the terminal insulator onto the generator rectifier end frame.



    A098216E01
  1. Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



3. INSTALL GENERATOR PULLEY


A097459E01
  1. Install the generator pulley onto the generator rotor shaft, and then temporarily tighten the generator pulley nut by hand.



    A097454E02
  1. Tighten SST 1-B to the specified torque, and then fix SST 1-A on the generator rotor shaft.

    SST
    09820-63011   (09820-06010, 09820-06021)
    Item
    Part No.
    SST 1-A and B
    09820-06010
    SST 2
    09820-06021

    Torque:
    39 N*m{ 400 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Securely fix SST on the generator rotor shaft.



    A097455E02
  1. Clamp SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and then fix the generator pulley nut into SST 2.



    A097457E02
  1. Turn SST 1-A in the direction shown, and then loosen the generator pulley nut.

    Torque:
    133 N*m{ 1,356 kgf*cm , 98 ft.*lbf }

  1. Remove the generator from SST 2.



    A097458E02
  1. Fix SST 1-B in place, then loosen SST 1-A in the direction shown. Remove SST 1-A and B from the generator.

  1. Turn the generator pulley, and then check that the generator pulley moves smoothly.