Home › ENGINE ยท 2AZ-FE › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR ROTOR ASSEMBLY


    A097468
  1. Install the washer onto the generator rectifier end frame.



    A097467E01
  1. Install the generator rotor onto the generator rectifier end frame.



    A097475E02
  1. Using a 32 mm socket wrench and press, slowly push the generator drive end frame onto the generator rectifier end frame.



    A097465E01
  1. Tighten the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



    A097464E01
  1. Install the cord clip with the bolt.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



2. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A079315E04
  1. While pushing the 2 brushes into the generator brush holder, insert a 1.0 mm (0.039 in.) pin into the generator brush holder.



    A097463E02
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull the pin out of the generator brush holder.



    A097461E01
  1. Install the terminal insulator onto the generator rectifier end frame.



    A098216E01
  1. Install the generator rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



3. INSTALL GENERATOR PULLEY WITH CLUTCH
  1. Install the pulley by hand.



    A126778E01
  1. Install SST to the pulley and vise as shown in the illustration.

    SST
    09820-63021  



    A126782E01
  1. Turn SST (B) counterclockwise to tighten the pulley.

    Torque:
    80 N*m{ 816 kgf*cm , 59 ft.*lbf }

  1. Install a new cap to the pulley.

  1. Check that the generator pulley rotates smoothly.