Home › ENGINE · 3ZR-FAE › COOLING › COOLING FAN RELAY

COOLING FAN RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE ENGINE ROOM NO. 2 RELAY BLOCK COVER


2. INSPECT NO. 1 COOLING FAN RELAY (FAN NO. 1)


B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the No. 1 cooling fan relay.

  1. Install the relay.



3. INSPECT NO. 2 COOLING FAN RELAY (FAN NO. 2)


A087121E01
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 4
    Battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    1. If the result is not as specified, replace the No. 2 cooling fan relay.

  1. Install the relay.



4. INSPECT NO. 3 COOLING FAN RELAY (FAN NO. 3)


B060778E45
  1. Remove the relay from the engine room No. 2 relay block.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Battery voltage is applied to terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the No. 3 cooling fan relay.

  1. Install the relay.



5. INSTALL ENGINE ROOM NO. 2 RELAY BLOCK COVER