Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › AIR CONDITIONING UNIT

AIR CONDITIONING UNIT > REASSEMBLY

for Preparation Click here



1. INSTALL EVAPORATOR TEMPERATURE SENSOR

NOTICE:
If reusing the evaporator, do not insert the sensor to a location where the sensor was previously inserted. Insert the sensor within range C shown in the illustration.



    E124283E01
  1. Install the evaporator temperature sensor as shown in the illustration.



2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY


    E124281
  1. Install the cooler thermistor and cooler evaporator on the case.

  1. Attach the temperature sensor clamp.



    E124280
  1. Attach the 2 claws to install the cover.

  1. Install the 4 screws.



3. INSTALL COOLER EXPANSION VALVE


    E124278
  1. Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the hose joint.

    Compressor oil:
    ND-OIL 8 or equivalent

  1. Install the 2 O-rings to the cooler evaporator.

  1. Install the cooler expansion valve.

  1. Using a 4 mm hexagon wrench, install the A/C tube with the 2 hexagon bolts.

    Torque:
    3.5 N*m{ 35 kgf*cm , 30 in.*lbf }



4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY


    E124279
  1. Install the heater radiator with the clamp and screw.



5. INSTALL AIRMIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)


    H102209
  1. Attach the 3 claws to install the cable.



6. INSTALL MODE CONTROL CABLE ASSEMBLY (for Manual Air Conditioning System)


    H102208
  1. Attach the 3 claws to install the cable.



    E127171
  1. Attach the evaporator case to the blower case.

  1. Install the blower case with the 3 screws.



7. INSTALL AIR MIX CONTROL SERVO MOTOR (for Automatic Air Conditioning System)


    E124276
  1. Install the air mix control servo motor with the 3 screws and connect the connector.



8. INSTALL AIR OUTLET CONTROL SERVO MOTOR (for Automatic Air Conditioning System)


    E124277
  1. Install the air outlet control servo motor with the 3 screws and connect the connector.



    E127171
  1. Attach the evaporator case to the blower case.

  1. Install the 3 screws.



9. INSTALL AIR DUCT


    E126460
  1. Attach the 2 claws to install the air duct.



10. INSTALL NO. 3 HEATER TO REGISTER DUCT


    E127161
  1. Attach the 6 claws to install the heater to register duct.