COMPRESSOR AND PULLEY (for 3ZR-FAE) > INSTALLATION |
| 1. ADJUST COMPRESSOR OIL |
When replacing the compressor assembly with pulley with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor assembly with pulley before installation.
| 2. INSTALL COOLER COMPRESSOR ASSEMBLY |
![]() |
Install the cooler compressor with the 2 stud bolts.
![]() |
Install the 2 bolts and 2 nuts.
![]() |
Connect the connector.
| 3. INSTALL NO. 1 COOLER REFRIGERANT SUCTION HOSE |
![]() |
Remove the vinyl tape from the hose and compressor.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Install the O-ring to the cooler refrigerant suction hose.
Install the cooler refrigerant suction hose to the cooler compressor with the bolt.
| 4. INSTALL NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the attached vinyl tape from the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Install the O-ring to the cooler refrigerant discharge hose.
Install the cooler refrigerant discharge hose to the cooler compressor with the bolt.
| 5. INSTALL FAN & GENERATOR V BELT |
Temporarily install the V-ribbed belt.
| 6. INSTALL RADIATOR RESERVOIR ASSEMBLY |
![]() |
Connect the radiator reservoir with the 2 bolts.
Connect the No. 1 and No. 2 water by-pass hoses.
| 7. INSTALL RADIATOR SUPPORT OPENING COVER |
![]() |
Install the radiator support opening cover with the 9 clips.
| 8. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH |
![]() |
Install the reinforcement with the 4 bolts.
| 9. INSTALL REAR ENGINE UNDER COVER RH |
![]() |
Install the under cover with the 3 clips.
| 10. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Install the under cover with the 6 screws and 10 clips.
| 11. INSTALL FRONT WHEEL RH |
| 12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 13. CHARGE REFRIGERANT |
Perform vacuum purging using a vacuum pump.
Charge refrigerant HFC-134a (R134a).

| 14. WARM UP ENGINE |
Warm up the engine at less than 1,850 rpm for 2 minutes or more after charging the refrigerant.
| 15. INSPECT FOR REFRIGERANT LEAK |
After recharging the refrigerant gas, check for refrigerant gas leakage using a halogen leak detector.
Perform the operation under these conditions:
![]() |
Using a gas leak detector, check the refrigerant line for leakage.
If a gas leak is not detected on the drain hose, remove the blower motor control (blower resistor) from the cooling unit. Insert the gas leak detector sensor into the unit and perform the test.
Disconnect the connector and leave the pressure switch on for approximately 20 minutes. Bring the gas leak detector close to the pressure switch and perform the test.