COMPRESSOR AND MAGNETIC CLUTCH (for 2GR-FE) > REMOVAL |
| 1. REMOVE RADIATOR SUPPORT OPENING COVER |
![]() |
Remove the 9 clips and cover.
| 2. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM |
Start the engine.
Turn the A/C switch on.
Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.
Stop the engine.
Recover the refrigerant from the A/C system using a refrigerant recovery unit.
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Detach the 3 clips and remove the V-bank cover.
| 5. DISCONNECT RADIATOR RESERVE TANK ASSEMBLY |
![]() |
Remove the 2 bolts and disconnect the reservoir tank.
| 6. REMOVE NO. 1 ENGINE UNDER COVER |
Remove the 2 bolts, 4 screw, 10 clips and under cover.
| 7. REMOVE REAR ENGINE UNDER COVER RH |
Remove the 2 clips and under cover.
| 8. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH |
![]() |
Remove the 4 bolts and reinforcement.
| 9. REMOVE V-RIBBED BELT |
![]() |
Rotate the tensioner pulley counterclockwise to loosen the belt tension. Then remove the V-ribbed belt.
![]() |
While turning the belt tensioner counterclockwise, align its holes, and then insert a 5 mm bi-hexagon wrench into the holes to fix the V-ribbed belt tensioner in place.
| 10. DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE |
![]() |
Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant suction hose.
| 11. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE |
![]() |
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant discharge hose.
| 12. REMOVE COOLER COMPRESSOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 4 bolts and cooler compressor.