Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND PULLEY (for 3ZR-FAE)

COMPRESSOR AND PULLEY (for 3ZR-FAE) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start the engine.

  1. Turn the A/C switch on.

  1. Operate the cooler compressor while the engine speed is approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.

    SST
    09985-20010   (09985-02130, 09985-02150, 09985-02090, 09985-02110, 09985-02010, 09985-02050, 09985-02060, 09985-02070)



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE FRONT WHEEL RH


4. REMOVE NO. 1 ENGINE UNDER COVER


    A206200
  1. Remove the 6 screws, 10 clips and under cover.



5. REMOVE REAR ENGINE UNDER COVER RH


    A196892
  1. Remove the 3 clips and under cover.



6. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH


    A206202
  1. Remove the 4 bolts and reinforcement.



7. REMOVE RADIATOR SUPPORT OPENING COVER


B209240
  1. Remove the 9 clips and radiator support opening cover.



8. REMOVE RADIATOR RESERVOIR ASSEMBLY


    A209177
  1. Disconnect the No. 1 and No. 2 water by-pass hoses.

  1. Remove the 2 bolts and radiator reservoir.



9. REMOVE FAN & GENERATOR V BELT


    A165469E01
  1. Loosen bolts A and B.

  1. Loosen bolt C and remove the V-ribbed belt.

    NOTICE:
    Do not loosen bolt D.



10. REMOVE NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


E179525
  1. Remove the bolt and remove the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



11. REMOVE NO. 1 COOLER REFRIGERANT SUCTION HOSE


E179526
  1. Remove the bolt and remove the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



12. REMOVE COOLER COMPRESSOR ASSEMBLY


E179527
  1. Disconnect the connector.



    E179528
  1. Remove the 2 bolts and 2 nuts.



    E179529
  1. Remove the 2 stud bolts and cooler compressor.