Home › TRANSMISSION ยท U151F AUTOMATIC TRANSAXLE › FORWARD CLUTCH

FORWARD CLUTCH > INSPECTION

for Preparation Click here



1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH


    D026715E01
  1. Install the forward clutch on the oil pump.

    NOTICE:
    Be careful not to damage the oil seal ring of the oil pump.

  1. Using a dial indicator, measure the forward clutch pack clearance while applying and releasing compressed air (392 kPa, 4.0 kgf/cm2, 57 psi).

    Standard pack clearance:
    1.00 to 1.25 mm (0.0394 to 0.0492 in.)

    If the clearance is not as specified, inspect the discs, plates and flange.

    HINT:
    If the opening is large, cover it with a piece of cloth to prevent compressed air from escaping.



2. INSPECT FORWARD MULTIPLE DISC CLUTCH DISC


    D009189E01
  1. Check if the sliding surfaces of the discs, plates and flange are worn or burnt.
    If necessary, replace them.

    NOTICE:
    1. If the lining of a disc comes off or is discolored, or if a part of the groove is worn, replace all the discs.
    2. Before installing new discs, immerse them in ATF for at least 15 minutes.



3. INSPECT FORWARD CLUTCH RETURN SPRING SUB-ASSEMBLY


    D009211E03
  1. Using a vernier caliper, measure the free length of the spring together with the spring seat.

    Standard free length:
    26.74 mm (1.0528 in.)



4. INSPECT FORWARD MULTIPLE DISC CLUTCH DISC


    D003672E01
  1. Check if the disc lightly rotates when rotating the forward clutch after inserting the multiple disc clutch into it.

    NOTICE:
    Do not place the forward clutch in a vise.