DTC P0717 Input Speed Sensor Circuit No Signal |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0717 | ECM detects conditions (a), (b) and (c) continuously for 5 sec. or more (1 trip detection logic): (a) Vehicle speed: 50 km/h (31 mph) or more (b) Park/Neutral position switch (NSW, R and L) is OFF (c) Speed sensor NT: Less than 300 rpm |
|

| Item | Measurement Item/ Range (Display) | Normal Condition | Diagnostic Note |
| SPD (NT) | Input turbine speed/ Min.: 0 rpm Max.: 12,750 rpm |
| Data is displayed in increments of 50 rpm |
| 1.INSPECT SPEED SENSOR (INSTALLATION) |
![]() |
Check the speed sensor NT installation.
|
| ||||
| OK | |
| 2.INSPECT SPEED SENSOR NT |
![]() |
Disconnect the B30 sensor connector from the transaxle.
Measure the resistance of the sensor.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 560 to 680 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (SPEED SENSOR - ECM) |
Connect the speed sensor connector.
![]() |
Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| B32-125 (NT+) - B32-124 (NT-) | 20°C (68°F) | 560 to 680 Ω |
| B32-125 (NT+) - Body ground | 20°C (68°F) | 10 kΩ or higher |
| B32-124 (NT-) - Body ground | 20°C (68°F) | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||