PARK / NEUTRAL POSITION SWITCH > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 6 screws, 10 clips and under cover.
| 2. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY |
Move the shift lever to N.
![]() |
Remove the nut and disconnect the control cable from the control shaft lever.
| 3. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the park/neutral position switch connector.
![]() |
Remove the nut, washer and control shaft lever.
![]() |
Using a screwdriver, bend the tabs of the lock plate.
| *1 | Lock Plate |
Remove the lock nut and lock plate.
![]() |
Remove the 2 bolts and pull out the park/neutral position switch assembly to remove it.