CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
Remove the engine with transaxle (Click here).
| 2. DISCONNECT WATER BY-PASS HOSE |
![]() |
Disconnect the 2 water by-pass hoses from the oil cooler.
| 3. REMOVE OIL COOLER |
![]() |
Disconnect the 2 oil cooler hoses from the continuously variable transaxle.
Remove the 3 bolts and oil cooler from the continuously variable transaxle.
| 4. REMOVE STARTER ASSEMBLY |
![]() |
Disconnect the terminal cap.
Remove the nut and disconnect the starter wire.
Disconnect the connector.
Remove the 2 bolts and starter.
| 5. REMOVE ENGINE MOUNTING BRACKET LH |
![]() |
Remove the 3 bolts and engine mounting bracket LH from the continuously variable transaxle.
| 6. REMOVE FRONT ENGINE MOUNTING BRACKET |
![]() |
Remove the 3 bolts and front engine mounting bracket from the continuously variable transaxle.
| 7. REMOVE REAR ENGINE MOUNTING BRACKET |
![]() |
Remove the 3 bolts and rear engine mounting bracket from the continuously variable transaxle.
| 8. REMOVE GROUND CABLE |
![]() |
Detach the clamp.
Remove the bolt and ground cable.
| 9. DISCONNECT ENGINE WIRE |
for Front Side:
Disconnect the transmission wire connector, park/neutral position switch connector and 3 revolution sensor connectors, and detach the 3 wire harness clamps from the continuously variable transaxle.
for Rear Side:
Disconnect the oil pressure sensor connector and detach the 2 wire harness clamps from the continuously variable transaxle.

| 10. REMOVE DRIVE PLATE AND TORQUE CONVERTER SETTING BOLT |
![]() |
Remove the flywheel housing under cover.
Turn the crankshaft to gain access to the 6 bolts and remove each bolt while holding the crankshaft pulley bolt with a wrench.
| 11. REMOVE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
![]() |
Remove the 8 bolts and continuously variable transaxle from the engine.
| 12. REMOVE TRANSFER ASSEMBLY |
![]() |
except K111F:
Remove the 6 nuts, 2 bolts and transfer from the transaxle.
![]() |
for K111F:
Remove the 6 nuts and transfer from the transaxle.
| 13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET |
![]() |
Remove the 2 bolts and transmission control cable bracket from the continuously variable transaxle.
| 14. REMOVE WIRE HARNESS CLAMP BRACKET |
Remove the 4 bolts and 4 wire harness clamp brackets from the continuously variable transaxle.

| 15. REMOVE TORQUE CONVERTER ASSEMBLY |
Remove the torque converter from the continuously variable transaxle.
| 16. REMOVE CVT OIL PUMP TYPE T OIL SEAL |
![]() |
Clean the tips of both the claws of the SST and the center bolt.
Using the SST, remove the CVT oil pump type T oil seal.