DTC P0746 Pressure Control Solenoid "A" Performance (Shift Solenoid Valve SL1) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0746 | Gear required by the ECM does not match the actual gear when driving (2 trip detection logic) |
|
| Item | Test Detail | Diagnostic Note |
| Control the shift position | [Test Details] Operate shift solenoid valve and set each shift lever position by yourself [Vehicle Condition]
| Possible to check operation of shift solenoid valves |
| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0746) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| Only P0746 is output | A |
| P0746 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT SHIFT SOLENOID VALVE SL1 |
![]() |
Remove the shift solenoid valve SL1.
Measure the resistance of the solenoid valve.
Connect the battery's positive (+) lead with a 21 W bulb to terminal 2 and the negative (-) lead to terminal 1 of the solenoid valve connector. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | |
| 3.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 4.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||