DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0741 | Lock-up does not occur when driving in lock-up range Lock-up remains ON in lock-up OFF range (2 trip detection logic) |
|

| Item | Test Detail | Diagnostic Note |
| Activate the Lock Up | [Test Details] Control shift solenoid DSL to set automatic transaxle to the lock-up condition [Vehicle Condition]
| Possible to check shift solenoid valve DSL operation |

| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Enter the following menus: Powertrain / Engine and ECT / DTC / Current or Pending.
Read the DTCs using the tester.
| Display (DTC output) | Proceed to |
| Only P0741 is output | A |
| P0741 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSL) |
![]() |
Disconnect the B29 wire connector.
Measure the resistance of the transmission wire.
| Tester Connection | Condition | Specified Condition |
| 3 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | |
| 3.CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM) |
Connect the B29 wire connector.
![]() |
Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| B32-79 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | |
| 4.INSPECT SHIFT SOLENOID VALVE DSL |
![]() |
Remove the shift solenoid valve DSL.
Measure the resistance of the solenoid valve.
Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | |
| 5.CHECK TRANSMISSION WIRE |
|
| ||||
| OK | |
| 6.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 7.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly (Click here).
|
| ||||
| OK | ||
| ||