DTC P0741 Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve DSL) |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0741 | Lock-up does not occur when driving in the lock-up range, or lock-up remains ON in the lock-up OFF range (2 trip detection logic). |
|

| ACTIVE TEST |
Warm up the engine.
Turn the ignition switch off.
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
According to the display on the tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Activate the Lock Up | Control shift solenoid valve DSL to set automatic transaxle to lock-up | ON or OFF | It is possible to check shift solenoid valve DSL operation. [Vehicle Condition]
|
Lightly depress the accelerator pedal and check that the engine speed does not change abruptly.

| 1.CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P0741) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / DTC.
Read the DTCs using the tester.
| Result | Proceed to |
| Only P0741 is output | A |
| P0741 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSL) |
![]() |
Disconnect the B29 transmission wire connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 3 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
| *a | Component without harness connected (Transmission Wire) |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
![]() |
Disconnect the B32 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| B32-79 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
| *a | Front view of wire harness connector (to ECM) |
|
| ||||
| OK | ||
| ||
| 4.INSPECT SHIFT SOLENOID VALVE DSL |
![]() |
Remove shift solenoid valve DSL.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| Shift solenoid valve DSL connector terminal - Shift solenoid valve DSL body | 20°C (68°F) | 11 to 13 Ω |
Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
| Measurement Condition | Specified Condition |
| Valve moves and makes an operating noise |
| *a | Component without harness connected (Shift Solenoid Valve DSL) |
|
| ||||
| OK | |
| 5.CHECK TRANSMISSION WIRE |
Check the transmission wire.
|
| ||||
| OK | |
| 6.INSPECT TRANSMISSION VALVE BODY ASSEMBLY |
Check the transmission valve body assembly.
|
| ||||
| OK | |
| 7.INSPECT TORQUE CONVERTER CLUTCH ASSEMBLY |
Check the torque converter clutch assembly.
|
| ||||
| OK | ||
| ||