Home › TRANSMISSION ยท EB61 MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > INSPECTION

for Preparation Click here



1. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


    C200234
  1. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.00197 to 0.00787 in.)

    If the backlash is not as specified, replace the side gear thrust washers with washers of a different thickness. Use the table below to select a side gear thrust washer which will ensure that the backlash is within the specification.

    Standard Thrust Washer Thickness:
    Mark
    Specified Condition
    1
    1.00 mm (0.0394 in.)
    2
    1.10 mm (0.0433 in.)
    3
    1.20 mm (0.0472 in.)
    4
    1.30 mm (0.0511 in.)

    HINT:
    Select washers of the same thickness for both the right and left sides.



2. INSPECT FRONT DIFFERENTIAL PINION THRUST WASHER


    C193762
  1. Using a micrometer, measure the thickness of the front differential pinion thrust washer.

    Minimum thickness:
    0.9 mm (0.0354 in.)

    If the thickness is less than the minimum, replace the front differential pinion thrust washer.



3. INSPECT FRONT NO. 1 DIFFERENTIAL PINION SHAFT


    C199374
  1. Using a micrometer, measure the outer diameter of the front No. 1 differential pinion shaft.

    Minimum outer diameter:
    17.975 mm (0.708 in.)

    If the outer diameter is less than the minimum, replace the front No. 1 differential pinion shaft.