Home › TRANSMISSION ยท EB61F MANUAL TRANSAXLE › DIFFERENTIAL CASE

DIFFERENTIAL CASE > DISASSEMBLY

for Preparation Click here



1. REMOVE FRONT DIFFERENTIAL CASE OIL SEAL


    C204251E01
  1. Using SST, remove the front differential case oil seal from the front differential case.

    SST
    09308-00010  



2. REMOVE FRONT DIFFERENTIAL RING GEAR


    C207064E01
  1. Place matchmarks on the front differential ring gear and front differential case.
    Text in Illustration 
    *1
    Matchmark



    C199117
  1. Remove the 12 bolts.

  1. Using a plastic-faced hammer, remove the front differential ring gear from the front differential case.



3. INSPECT FRONT DIFFERENTIAL SIDE GEAR BACKLASH


    C207068
  1. Using a dial indicator, measure the front differential side gear backlash.

    Standard backlash:
    0.05 to 0.20 mm (0.00197 to 0.00787 in.)

    If the backlash is not as specified, replace the side gear thrust washers with washers of a different thickness. Use the table below to select a side gear thrust washer which will ensure that the backlash is within the specification.

    Standard Thrust Washer Thickness:
    Mark
    Specified Condition
    1
    1.00 mm (0.0394 in.)
    2
    1.10 mm (0.0433 in.)
    3
    1.20 mm (0.0472 in.)
    4
    1.30 mm (0.0511 in.)

    HINT:
    Select washers of the same thickness for both the right and left sides.



4. REMOVE FRONT DIFFERENTIAL PINION SHAFT STRAIGHT PIN


    C199118E01
  1. Using SST and a hammer, loosen the staked part of the front differential case.

    SST
    09930-00010  



    C207065
  1. Using a 5 mm pin punch and hammer, tap out the front differential pinion shaft straight pin from the front differential case.



5. REMOVE FRONT NO. 1 DIFFERENTIAL PINION SHAFT


    C207066
  1. Remove the front No. 1 differential pinion shaft from the front differential case.



6. REMOVE FRONT DIFFERENTIAL SIDE GEAR


    C207067
  1. Remove the 2 front differential pinions, 2 front differential pinion thrust washers, 2 front No. 1 differential side gear thrust washers and 2 front differential side gears from the front differential case.

    HINT:
    While rotating the front differential side gears, remove the 2 pinions and 2 pinion thrust washers.