Home › TRANSMISSION ยท EB61 MANUAL TRANSAXLE › SHIFT AND SELECT LEVER SHAFT

SHIFT AND SELECT LEVER SHAFT > REASSEMBLY

for Preparation Click here



1. INSTALL RELEASE HEAD
  1. Install the release head to the shift and select lever shaft.



    C204828E01
  1. Using a 5 mm pin punch and hammer, tap in the slotted spring pin to the shift and select lever shaft.

    Standard depth:
    -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

    NOTICE:
    Make sure the installation direction is correct.



2. INSTALL FRONT INNER SHIFT LEVER
  1. Install the front inner shift lever to the shift and select lever shaft.



    C200230E01
  1. Using a 5 mm pin punch and hammer, tap in the front inner shift lever and slotted spring pin to the shift and select lever shaft.

    Standard depth:
    -0.2 to 0.8 mm (-0.00787 to 0.0315 in.)

    NOTICE:
    Make sure the installation direction is correct.



3. INSTALL INNER NO. 2 SHIFT LEVER
  1. Install the inner No. 2 shift lever to the shift and select lever shaft.



    C204829E01
  1. Using a 5 mm pin punch and hammer, tap in the inner No. 2 shift lever and slotted spring pin to the shift and select lever shaft.

    Standard depth:
    0 to 0.6 mm (0 to 0.0236 in.)

    NOTICE:
    Make sure the installation direction is correct.