Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › MANIFOLD ABSOLUTE PRESSURE SENSOR

MANIFOLD ABSOLUTE PRESSURE SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK VACUUM SENSOR ASSEMBLY


    A124891E03
  1. Inspect the power source voltage.

    1. Disconnect the vacuum sensor connector.

    2. Turn the ignition switch to ON.

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (VC) - 1 (E2)
      Ignition switch ON
      4.5 to 5.5 V

      Text in Illustration 
      *1
      Front view of wire harness connector
      (to Vacuum Sensor)

    4. Turn the ignition switch off.

    5. Reconnect the vacuum sensor connector.

  1. Check the vacuum and pressure.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON and turn the tester on.

    3. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

    4. Read the MAP value.

      OK:
      Condition
      Specified Condition
      No pressure applied
      Same as atmospheric pressure
      Vacuum applied
      Indicates vacuum
      Pressure applied
      Indicates pressure

      If the result is not as specified, replace the vacuum sensor.