Home › ENGINE ยท 3ZR-FAE › FUEL › FUEL TANK

FUEL TANK > REASSEMBLY

for Preparation Click here



1. INSTALL NO. 3 FUEL TANK PROTECTOR


    A209826
  1. Attach the 2 claws to install the protector.



2. INSTALL FUEL SENDER GAUGE ASSEMBLY


    A124671
  1. Install the sender gauge with the 5 screws.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf }



3. INSTALL NO. 1 FUEL TANK CUSHION


    A128746
  1. Install 7 new fuel tank cushions onto the fuel tank as shown in the illustration.



4. INSTALL AIR INLET LINE TUBE


    A178838
  1. Attach the 2 clamps to install the air inlet line tube to the fuel tank.



5. INSTALL NO. 1 FUEL TUBE CLAMP


    A124672
  1. Install the 4 tube clamps to the fuel tank.



6. INSTALL FUEL EVAPORATION TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.



7. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
  1. Install the tube to the fuel tube clamps.



8. INSTALL FUEL SUCTION WITH PUMP ASSEMBLY


    A126699E03
  1. Install a new gasket onto the fuel suction with pump.
    Text in Illustration 
    *1
    New Gasket



    A202412E01
  1. Connect the fuel hose with the paint mark facing towards the top of the vehicle, and then secure the clip.

  1. Install the fuel suction with pump into the fuel tank.

    NOTICE:
    Do not damage the fuel suction with pump.



9. INSTALL FUEL TANK VENT TUBE SET PLATE


    A124675
  1. Install the set plate with the 8 bolts.

    Torque:
    4.0 N*m{ 41 kgf*cm , 35 in.*lbf }



10. INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY


    A124668
  1. Install the fuel tube with the joint clip.

    NOTICE:
    A124131E05
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joint is inserted securely.
    3. Check that the fuel tube joint clip is on the collar of the fuel tube joint.
    4. After installing the tube joint clip, check that the fuel tube joint cannot be pulled off.
    5. Be careful not to damage the clip. If the clip is damaged, replace it.



11. INSTALL FUEL EMISSION HOSE


  1. Connect the purge line hose and air inlet line hose to the fuel suction plate.


    A213193E01


    Text in Illustration 
    *1
    Purge Line Hose
    *2
    Air Inlet Line Hose
    *3
    Fuel Emission Hose
    -
    -

    HINT:
    Make sure the direction of the hose clamps are as indicated in the illustration.

  1. Connect the fuel emission hose to the fuel suction plate.

    HINT:
    Firmly push the tube connector until a "click" sound is heard.

    NOTICE:
    1. Before connecting the hose, check if there is any damage or foreign matter in the hose or connector.
    2. Check that the connector is connected by pulling on it.