Home › ENGINE ยท 1AZ-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here


HINT:
The type of ignition switch on this model differs according to the specifications, of the vehicle. For the expressions used in this section, refer to "EXPRESSIONS OF IGNITION SWITCH" precaution (Click here).



1. CHECK ACCELERATOR PEDAL ROD


    B127990E01
  1. Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester ON.

    4. Select the menu items: Powertrain / Engine and ECT / Data List / All Data / Accelerator Position No. 1, Accelerator Position No. 2.

    5. Operate the accelerator pedal, and then check that the ACCEL POS #1 and ACCEL POS #2 values are within the specifications.

      Standard voltage (Accelerator Position No. 1):
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Standard voltage (Accelerator Position No. 2):
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.