Home › ENGINE ยท 2GR-FE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK ACCELERATOR PEDAL ROD
  1. Check the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the intelligent tester on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Accelerator Position No. 1, Accelerator Position No. 2.

    5. Operate the accelerator pedal, and then check that the values of Accelerator Position No. 1 and Accelerator Position No. 2 are within the specifications.

      Standard voltage:
      Accelerator Position No. 1
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Accelerator Position No. 2:
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.