Home › ENGINE ยท 3ZR-FAE › ENGINE CONTROL SYSTEM › ACCELERATOR PEDAL ROD

ACCELERATOR PEDAL ROD > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT ACCELERATOR PEDAL ROD


    B127990E01
  1. Check the voltage.

  1. Turn the ignition switch to ON.

  1. Turn the intelligent tester main switch on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sensor Out No. 1, Accel Sensor Out No. 2.

  1. Read the value displayed on the intelligent tester.

    Standard Voltage:
    Item
    Condition
    Specified Condition
    Accel Sensor Out No. 1
    Released
    0.5 to 1.1 V
    Depressed
    2.5 to 4.5 V
    Accel Sensor Out No. 2
    Released
    1.2 to 2.0 V
    Depressed
    3.4 to 5.0 V

    If the result is not as specified, check the accelerator pedal rod, wire harness or ECM.