Home › ENGINE · 1AZ-FE › CHARGING › BATTERY CURRENT SENSOR

BATTERY CURRENT SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK BATTERY CURRENT SENSOR ASSEMBLY


    A124656E01
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Specified Condition
    2 (VC5) - 4 (E2)
    0.1 to 10 kΩ
    2 (VC5) - 3 (IB)
    Below 0.5 kΩ
    3 (IB) - 4 (E2)
    0.05 to 10 kΩ

    If the result is not as specified, replace the sensor assembly.



    A125629E01
  1. Measure the resistance of the sensor.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    1 (THB) - 4 (E2)
    20 to 30°C (68 to 86°F)
    1.5 to 2.5 kΩ

    If the result is not as specified, replace the sensor assembly.