Home › TRANSMISSION ยท CLUTCH › CLUTCH UNIT (for 3ZR-FAE)

CLUTCH UNIT (for 3ZR-FAE) > INSPECTION

for Preparation Click here



1. INSPECT CLUTCH DISC ASSEMBLY


C205071
  1. Using a vernier caliper, measure the rivet head depth.

    Minimum rivet depth:
    0.3 mm (0.0118 in.)

    If the depth is less than the minimum, replace the clutch disc assembly.

  1. Install the clutch disc assembly onto the manual transaxle assembly.

    HINT:
    Insert the clutch disc assembly in the correct direction.



    C200455
  1. Using a dial gauge, measure the clutch disc assembly runout.

    Maximum runout:
    0.8 mm (0.0314 in.)

    If the runout is more than the maximum, replace the clutch disc assembly.



2. INSPECT CLUTCH COVER ASSEMBLY


C200454E01
  1. Using a vernier caliper, measure the depth and width of the diaphragm spring wear.

    Maximum:
    A (Depth): 0.5 mm (0.0196 in.)
    B (Width): 6.0 mm (0.236 in.)

    If the depth or width is more than the maximum, replace the clutch cover assembly.



3. INSPECT FLYWHEEL SUB-ASSEMBLY


C199334
  1. Using a dial gauge, check the flywheel sub-assembly runout.

    Maximum runout:
    0.1 mm (0.00393 in.)

    If the runout is more than the maximum, replace the flywheel sub-assembly.