MANUAL TRANSAXLE ASSEMBLY > REMOVAL |
| 1. REMOVE ENGINE ASSEMBLY WITH TRANSAXLE |
Remove the engine assembly with transaxle (Click here).
| 2. REMOVE STARTER ASSEMBLY |
| 3. REMOVE ENGINE WIRE |
![]() |
Remove the bolt, clamp and engine wire.
| 4. REMOVE MANUAL TRANSAXLE ASSEMBLY |
![]() |
Disconnect the back-up light switch connector and remove the bolt and engine wire from the manual transaxle.
![]() |
Remove the 8 bolts and manual transaxle.
| 5. REMOVE FRONT ENGINE MOUNTING BRACKET |
![]() |
Remove the 4 bolts and front engine mounting bracket.
| 6. REMOVE ENGINE MOUNTING BRACKET LH |
![]() |
Remove the 4 bolts and engine mounting bracket LH.
| 7. REMOVE REAR ENGINE MOUNTING BRACKET |
![]() |
Remove the 4 bolts and rear engine mounting bracket.
| 8. REMOVE ORIFICE TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench, separate the orifice to flexible hose tube from the clutch orifice assembly.
Remove the bolt and orifice to flexible hose tube.
| 9. REMOVE CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE |
![]() |
Using a union nut wrench, remove the clutch release cylinder to accumulator tube.
| 10. REMOVE CLUTCH ORIFICE ASSEMBLY |
![]() |
Remove the 2 bolts and clutch orifice assembly.
| 11. REMOVE CLUTCH FLEXIBLE HOSE BRACKET |
![]() |
Remove the bolt and clutch flexible hose bracket from the manual transaxle.
| 12. REMOVE CLUTCH RELEASE BLEEDER SUB-ASSEMBLY |
![]() |
Using a union nut wrench, separate the clutch release bleeder sub-assembly from the clutch release cylinder to bleeder tube.
Remove the 2 bolts and clutch release bleeder sub-assembly from the manual transaxle assembly.
| 13. REMOVE CLUTCH RELEASE WITH BEARING CYLINDER ASSEMBLY |
![]() |
Remove the clutch tube boot from the manual transaxle assembly.
![]() |
Remove the 3 bolts and clutch release with bearing cylinder assembly and clutch release cylinder to bleeder tube.
![]() |
Using a union nut wrench, remove the clutch release cylinder to bleeder tube from the clutch release with bearing cylinder assembly.
| 14. REMOVE SPEEDOMETER DRIVEN HOLE COVER SUB-ASSEMBLY |
![]() |
Remove the bolt and speedometer driven hole cover sub-assembly from the transaxle case.
Remove the O-ring from the speedometer driven hole cover sub-assembly.