Home › ENGINE · 3ZR-FAE › ENGINE CONTROL SYSTEM › CIRCUIT OPENING RELAY

CIRCUIT OPENING RELAY > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
w/ Navigation System (for HDD):
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. INSPECT MAIN BODY ECU

NOTICE:
The circuit opening relay is built into the main body ECU (instrument panel junction block).



  1. Measure the resistance according to the value(s) in the table below.


    E114510E61


    Text in Illustration 
    *1
    Component without harness connected
    (Main Body ECU)

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1B-11 - 1A-8
    Battery voltage not applied to terminals 1E-5 and 1D-1
    10 kΩ or higher
    1B-11 - 1A-8
    Battery voltage applied to terminals 1E-5 and 1D-1
    Below 1 Ω

    If the result is not as specified, replace the main body ECU.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL