Home › ENGINE · 2GR-FE › ENGINE CONTROL SYSTEM › IGNITION RELAY NO. 2

IGNITION RELAY NO. 2 > ON-VEHICLE INSPECTION

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE IG2 RELAY
  1. Remove the engine room No. 1 relay block cover.

  1. Remove the IG2 relay from the engine room No. 1 relay block.



3. INSPECT IG2 RELAY


    B060778E14
  1. Measure the resistance of the IG2 relay.

    Standard resistance:
    Tester Connection
    Specified Condition
    3 - 5
    10 kΩ or higher
    3 - 5
    Below 1 Ω
    (when battery voltage is applied to terminals 1 and 2)

    If the result is not as specified, replace the relay.



4. INSTALL IG2 RELAY


5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL