DTC P2769 Torque Converter Clutch Solenoid Circuit Low (Shift Solenoid Valve DSL) |
DTC P2770 Torque Converter Clutch Solenoid Circuit High (Shift Solenoid Valve DSL) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2769 | ECM detects short in shift solenoid valve DSL circuit when shift solenoid valve DSL is operated (2 trip detection logic) |
|
| P2770 | ECM detects open in shift solenoid valve DSL circuit when shift solenoid valve DSL is not operated (2 trip detection logic) |
|
| 1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE DSL) |
![]() |
Disconnect the B29 wire connector.
Measure the resistance of the transmission wire.
| Tester Connection | Condition | Specified Condition |
| 3 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | |
| 2.CHECK WIRE HARNESS (TRANSMISSION WIRE - ECM) |
Connect the B29 wire connector.
![]() |
Disconnect the B32 ECM connector.
Measure the resistance of the wire harness side connector.
| Tester Connection | Condition | Specified Condition |
| B32-79 (DSL) - Body ground | 20°C (68°F) | 11 to 13 Ω |
|
| ||||
| OK | ||
| ||
| 3.INSPECT SHIFT SOLENOID VALVE DSL |
![]() |
Remove the shift solenoid valve DSL.
Measure the resistance between the solenoid valve terminal and solenoid valve body.
Connect the battery's positive (+) lead to the terminal of the solenoid valve connector, and the negative (-) lead to the solenoid body. Then check that the valve moves and makes an operating noise.
|
| ||||
| OK | ||
| ||