PARKING BRAKE LEVER > INSTALLATION |
| 1. INSTALL PARKING BRAKE SWITCH ASSEMBLY |
Install the parking brake switch with the screw.
| 2. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY |
Connect the cable to the lever.
| 3. INSTALL PARKING BRAKE LEVER SUB-ASSEMBLY |
![]() |
Install the parking brake lever (with the No. 1 parking brake cable) with the 2 bolts.
![]() |
Connect the No. 1 parking brake cable to the parking brake equalizer.
![]() |
Temporarily install the wire adjusting nut and lock nut.
Connect the parking brake switch connector.
| 4. CHECK PARKING BRAKE LEVER TRAVEL |
Pull the lever upward with a force of approximately 200 N (20 kgf, 44 lbf) and count the number of clicks.
| 5. ADJUST PARKING BRAKE LEVER TRAVEL |
![]() |
Turn the No. 1 wire adjusting nut until the lever travel is correct.
Tighten the lock nut.
Operate the parking brake lever 3 to 4 times, and check the parking brake lever travel.
When operating the parking brake lever, check that the brake warning light illuminates at the first click.
| 6. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY |
Install the rear console box (Click here).
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |