Home › BRAKE › PARKING BRAKE › PARKING BRAKE LEVER

PARKING BRAKE LEVER > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.



2. REMOVE REAR CONSOLE BOX SUB-ASSEMBLY
  1. Remove the rear console box (Click here).

    HINT:
    Refer to the procedures from the removal of the No. 1 console upper panel garnish up until the removal of the rear console box sub-assembly.



3. REMOVE PARKING BRAKE LEVER SUB-ASSEMBLY
  1. Disconnect the parking brake switch connector.



    C129091
  1. Remove the lock nut and wire adjusting nut.



    C129065
  1. Disconnect the No. 1 parking brake cable from the parking brake equalizer.



    C129092
  1. Remove the 2 bolts and parking brake lever (with the No. 1 parking brake cable).



4. REMOVE NO. 1 PARKING BRAKE CABLE ASSEMBLY
  1. Disconnect the cable from the lever.



5. REMOVE PARKING BRAKE SWITCH ASSEMBLY
  1. Remove the screw and switch from the lever.