SFI SYSTEM > VC Output Circuit |


| 1.CHECK MIL CONDITION |
Check that the Malfunction Indicator Lamp (MIL) lights up when turning the ignition switch on (IG).
|
| ||||
| NG | |
| 2.CHECK CONNECTION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and tester ON.
Check the communication between the tester and ECM.
| Result | Proceed to |
| Communication is possible | A |
| Communication is not possible | B |
|
| ||||
| B | |
| 3.CHECK MIL (BATTERY CURRENT SENSOR ASSEMBLY) |
Disconnect the B31 battery current sensor connector.
Turn the ignition switch on (IG).
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the battery current sensor connector.
|
| ||||
| B | |
| 4.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the B3 throttle body connector.
Turn the ignition switch on (IG).
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the throttle body connector.
|
| ||||
| B | |
| 5.CHECK MIL (ACCELERATOR PEDAL POSITION SENSOR) |
Disconnect the A6 accelerator pedal position sensor connector.
Turn the ignition switch on (IG).
Check the MIL.
| Result | Proceed to |
| MIL illuminates | A |
| MIL does not illuminate | B |
Reconnect the accelerator pedal position sensor connector.
|
| ||||
| B | |
| 6.CHECK HARNESS AND CONNECTOR |
Disconnect the B31 battery current sensor connector.
Disconnect the B3 throttle body connector.
Disconnect the A6 accelerator pedal position sensor connector.
![]() |
Disconnect the A12 and B32 ECM connectors.
Measure the resistance.
| Tester Connection | Specified Condition |
| VCIB (B32-69) - Body ground | 10 kΩ or higher |
| VCTA (B32-67) - Body ground | |
| VCPA (A12-57) - Body ground | |
| VCP2 (A12-58) - Body ground |
Reconnect the battery current sensor connector.
Reconnect the throttle body connector.
Reconnect the accelerator pedal position sensor connector.
Reconnect the ECM connectors.
|
| ||||
| OK | ||
| ||