AIR INLET CONTROL SERVO MOTOR > INSTALLATION |
| 1. INSTALL AIR INLET CONTROL SERVO MOTOR |
![]() |
Inspect the servo motor operation.
![]() |
Connect the positive (+) lead from the battery to terminal 5 and negative (-) lead to terminal 1, and then check that the arm turns to the "FRESH" side smoothly.
Connect the positive (+) lead from the battery to terminal 1 and negative (-) lead to terminal 5, and then check that the arm turns to the "RECIRCULATION" side smoothly. if the operation is not as specified, replaced the air inlet servo motor.
| 2. INSTALL BLOWER UNIT ASSEMBLY |
Install the blower .