CLUTCH MASTER CYLINDER (for LHD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT WIPER ARM HEAD CAP |
Remove the 2 caps.
| 3. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY LH |
![]() |
Remove the nut and arm and blade.
| 4. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY RH |
![]() |
Remove the nut and arm and blade.
| 5. REMOVE FRONT FENDER TO COWL SIDE SEAL LH |
![]() |
Detach the claw and remove the front fender to cowl side seal.
| 6. REMOVE FRONT FENDER TO COWL SIDE SEAL RH |
![]() |
Detach the claw and remove the front fender to cowl side seal.
| 7. REMOVE COWL TOP VENTILATOR LOUVER |
![]() |
Remove the 2 clips.
Detach the 12 claws and remove the louver.
| 8. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY |
![]() |
Remove the 2 bolts.
Move the wiper cushion in the direction shown by the arrow in the illustration to detach the wiper cushion from the body, and remove the wiper motor and link.
Disconnect the connector and detach the clamp.
| 9. REMOVE COWL VENTILATOR HOUSING SUB-ASSEMBLY |
![]() |
Detach the 4 claws and remove the ventilator housing.
| 10. REMOVE COWL TOP PANEL OUTER SUB-ASSEMBLY |
![]() |
Remove the 14 bolts and cowl top panel outer.
| 11. REMOVE COWL BODY MOUNTING REINFORCEMENT LH |
![]() |
Remove the 2 nuts and mounting reinforcement.
| 12. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Remove the 2 screws.
Detach the 3 claws and remove the cover.
| 13. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() |
Remove the 4 bolts and driver side knee airbag.
Disconnect the connector.
| 14. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() |
Remove the 2 screws.
Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.
| 15. DISCONNECT CLUTCH MASTER CYLINDER PUSH ROD CLEVIS |
![]() |
Remove the clip and pin, and disconnect the push rod clevis from the clutch pedal.
| 16. DRAIN BRAKE FLUID |
| 17. DISCONNECT CLUTCH RESERVOIR TUBE |
![]() |
Loosen the clip and disconnect the tube from the clutch master cylinder.
| 18. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench, disconnect the flexible hose tube.
| 19. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY |
Remove the 2 nuts and clutch master cylinder.