CLUTCH MASTER CYLINDER (for RHD) > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY |
![]() |
Remove the 2 screws.
Detach the 3 claws and remove the cover.
| 3. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY (w/ Knee Airbag) |
![]() |
Remove the 4 bolts and driver side knee airbag.
Disconnect the connector.
| 4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag) |
![]() |
Remove the 2 screws.
Using a screwdriver, detach the 8 claws and remove the lower instrument panel finish panel.
| 5. DRAIN BRAKE FLUID |
| 6. DISCONNECT CLUTCH RESERVOIR TUBE |
![]() |
Loosen the clip and disconnect the tube from the clutch master cylinder.
| 7. DISCONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE |
![]() |
Using a union nut wrench, disconnect the flexible hose tube.
| 8. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY |
![]() |
Remove the 2 nuts and clutch master cylinder.