Home › TRANSMISSION ยท CLUTCH › CLUTCH RELEASE CYLINDER (for 2AZ-FE)

CLUTCH RELEASE CYLINDER (for 2AZ-FE) > INSTALLATION

for Preparation Click here



1. INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY


C128484
  1. Install the clutch release cylinder with the 4 bolts.

    Torque:
    12 N*m{ 120 kgf*cm , 9 ft.*lbf }



2. CONNECT CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE


C128483
  1. Using a union nut wrench, connect the flexible hose tube.

    Torque:
    15 N*m{ 155 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Use the formula to calculate special torque values for situations where union nut wrench is combined with a torque wrench (Click here).



3. BLEED CLUTCH PIPE LINE
  1. Fill the brake reservoir with brake fluid and bleed the clutch system (Click here).

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }



4. INSPECT FLUID LEVEL


C126431
  1. Check the fluid level and add fluid if necessary.

    Fluid:
    SAE J1703 or FMVSS No. 116 DOT3

    HINT:
    Add fluid to a level between the reservoir's MIN and MAX lines.



5. REMOVE FOR FLUID LEAK
  1. Check for leaks in the clutch system.