DTC P0724 Brake Switch "B" Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains ON even when vehicle repeats 5 cycles of STOP (less than 1.86 mph [3 km/h]) and GO (18.65 mph [30 km/h] or more) (2 trip detection logic) |
|

| 1.READ VALUE USING INTELLIGENT TESTER (STOP LIGHT SWITCH) |
Connect the intelligent tester to the DLC3.
Turn the ignition switch on (IG) and turn the tester ON.
Select the following menu items: Powertrain / Engine and ECT / Data List / Stop Light Switch.
Read the values displayed on the tester.
| Item | Measurement Item / Range (display) | Normal Condition |
| Stop Light Switch | Stop light switch status: ON or OFF |
|
|
| ||||
| NG | |
| 2.INSPECT STOP LIGHT SWITCH ASSEMBLY |
![]() |
Remove the stop light switch assembly.
Measure the resistance.
| Tester Connection | Switch Position | Specified Condition |
| 1 - 2 | Switch pin not pushed | Below 1 Ω |
| Switch pin pushed | 10 kΩ or higher | |
| 3 - 4 | Switch pin not pushed | 10 kΩ or higher |
| Switch pin pushed | Below 1 Ω |
Reinstall the stop light switch assembly.
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - ECM) |
![]() |
Disconnect the A12 ECM connector.
Disconnect the A66 stop light switch connector.
Measure the resistance between the wire harness side connectors.
| Tester Connection | Specified Condition |
| STP (A12-36) - Stop light switch (A66-1) | Below 1 Ω |
| ST1- (A12-35) - Stop light switch (A66-3) |
| Tester Connection | Specified Condition |
| STP (A12-36) or Stop light switch (A66-1) - Body ground | 10 kΩ or higher |
| ST1- (A12-35) or Stop light switch (A66-3) - Body ground |
Reconnect the ECM connector.
Reconnect the stop light switch connector.
|
| ||||
| OK | ||
| ||