Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SPIRAL CABLE

SPIRAL CABLE > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.



    B127903E01
    B127902E01
  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connectors to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



    B127901E01
  1. Attach the 4 clips to the column cover (upper).



    B127900E02
  1. Install the steering column cover (upper).



2. INSTALL STEERING COLUMN COVER (LOWER)


    B127895E01
  1. Attach the 4 claws.



3. POSITION SPIRAL CABLE


B127904E01
  1. Slowly rotate the spiral cable counterclockwise by hand until it feels firm.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.



    B127905E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.

    NOTICE:
    Do not use the airbag wire harness to turn the spiral cable.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to the left and right from the center.



4. INSTALL STEERING WHEEL ASSEMBLY


    C195903E01
  1. Align the matchmarks and install the steering wheel to the steering column.

  1. Install the nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect all the connectors to the spiral cable.



5. INSTALL STEERING PAD ASSEMBLY
  1. for 1AZ-FE, 2AZ-FE

    1. Install the steering pad assembly (Click here).

  1. for 3RZ-FE

    1. Install the steering pad assembly (Click here).



6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



8. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).



9. INSPECT STEERING WHEEL POSITION