Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › DRIVER SIDE KNEE AIRBAG ASSEMBLY

DRIVER SIDE KNEE AIRBAG ASSEMBLY > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY


B127987
  1. Connect the connector.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Install the driver side knee airbag with the 4 bolts.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Attach the 2 guides and 2 claws to install the cover.



  1. Install the 2 screws.

    NOTICE:
    Securely insert the guide into the bracket shown in the illustration.



    B307870E01



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).