Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY
Remove the 4 bolts and driver side knee airbag.
Disconnect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.