CENTER AIRBAG SENSOR ASSEMBLY > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH |
![]() |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 4 clips and remove the upper panel garnish.
| 3. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH |
![]() |
Place protective tape as shown in the illustration.
Using a moulding remover, detach the 4 clips and remove the upper panel garnish.
| 4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, detach the 2 clips and 4 claws, and then remove the upper console panel.
| 5. REMOVE SWITCH BASE |
![]() |
Detach the 2 clips and 2 claws.
Disconnect the connectors and remove the switch base.
| 6. REMOVE CONSOLE CUP HOLDER BOX |
![]() |
Remove the 2 screws.
Detach the 2 clips and remove the cup holder box.
| 7. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Using a screwdriver, detach the 4 clips.
Disconnect the connectors and remove the upper rear console panel.
| 8. REMOVE CONSOLE REAR END PANEL |
![]() |
Using a screwdriver, detach the 6 claws and remove the console rear end panel.
| 9. REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER LH |
![]() |
Detach the 2 claws and remove the instrument panel bracket cover.
| 10. REMOVE NO. 1 INSTRUMENT PANEL BRACKET COVER INNER RH |
![]() |
Detach the 2 claws and remove the instrument panel bracket cover.
| 11. REMOVE REAR CONSOLE BOX ASSEMBLY |
![]() |
Remove the 2 bolts and detach the wire harness clamp.
![]() |
Remove the 2 screws.
Disconnect the connector and remove the rear console box.
| 12. REMOVE CENTER AIRBAG SENSOR ASSEMBLY |
![]() |
Disconnect the airbag sensor connectors.
Remove the 3 bolts and airbag sensor.