Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT AIRBAG SENSOR

FRONT AIRBAG SENSOR > INSTALLATION

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here ).



1. INSTALL FRONT AIRBAG SENSOR LH


B127920E01
  1. Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
    2. When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.

  1. Check that there is no free play in the installation parts of the sensor.

  1. Connect the sensor connector.



2. INSTALL FRONT AIRBAG SENSOR RH


B127921E01
  1. Install the sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
    2. When installing the airbag sensor, make sure that the SRS wiring does not interfere with other parts and is not pinched between other parts.

  1. Check that there is no free play in the installation parts of the sensor.

  1. Connect the sensor connector.



3. INSTALL RADIATOR SUPPORT OPENING COVER


4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


5. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).