Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › SIDE AIRBAG SENSOR

SIDE AIRBAG SENSOR > REMOVAL

for Preparation Click here


CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE FRONT DOOR SCUFF PLATE LH


    B129699
  1. Using a screwdriver, detach the 10 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)


B129703
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



5. REMOVE CENTER PILLAR GARNISH LOWER LH


    B131505E01
  1. Remove the lap belt outer anchor cover.

  1. Remove the anchor's built-in bolt from the pillar and disconnect the outer belt.



    B129700
  1. Using a screwdriver, detach the 2 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



6. REMOVE SIDE AIRBAG SENSOR ASSEMBLY LH


B127915E01
  1. Disconnect the connector.

  1. Remove the bolt and sensor.