Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › REAR AIRBAG SENSOR

REAR AIRBAG SENSOR > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.

CAUTION:
Be sure to read the precautionary notices concerning the SRS airbag system before servicing it (Click here).



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
w/ Navigation System for HDD:
After the ignition switch is turned off, the HDD navigation system requires approximately a minute to record various types of memory and settings. As a result, after turning the ignition switch off, wait a minute or more before disconnecting the cable from the negative (-) battery terminal.



2. REMOVE REAR DOOR SCUFF PLATE LH (for Short Body)


    B129711
  1. Using a screwdriver, detach the 8 claws and remove the scuff plate.

    HINT:
    Tape the screwdriver tip before use.



3. REMOVE REAR DOOR SCUFF PLATE LH (for Long Body)


B129703
  1. Using a screwdriver, detach the 9 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 2 clips and remove the garnish.



4. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


5. REMOVE PACKAGE TRAY TRIM POCKET SUB-ASSEMBLY


6. REMOVE TONNEAU COVER ASSEMBLY


7. REMOVE REAR FLOOR NO. 1 BOARD


8. REMOVE DECK BOARD ASSEMBLY


9. REMOVE REAR FLOOR NO. 2 BOARD


10. REMOVE REAR FLOOR NO. 3 BOARD


11. REMOVE JACK CARRIER ASSEMBLY (for Short Body)


B129715
  1. Using a clip remover, remove the 7 clips and remove the jack carrier.



12. REMOVE REAR NO. 1 FLOOR MAT SUPPORT SIDE PLATE


B129717
  1. Remove the 4 screws.

  1. Using a clip remover, detach the 7 clips and remove the plate.



13. REMOVE BACK DOOR WEATHERSTRIP


14. REMOVE REAR FLOOR FINISH PLATE (for Short Body)


    B129716
  1. Using a clip remover, detach the 6 clips and remove the finish plate.



15. REMOVE REAR FLOOR FINISH PLATE (for Long Body)


B129704
  1. Using a clip remover, detach the 6 clips.

  1. Detach the 2 claws and remove the finish plate.



16. REMOVE RECLINING REMOTE CONTROL LEVER SUB-ASSEMBLY LH


17. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER (for Short Body)


18. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR BRACKET (for Short Body)


19. DISCONNECT REAR NO. 1 SEAT BELT ASSEMBLY OUTER LH


B133643
  1. Remove the lap belt outer anchor cover.

  1. Remove the bolt and disconnect the floor anchor.



20. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Short Body)


    B137546
  1. Disconnect the rear No. 1 seat belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129712
  1. Remove the bolt and 2 screws.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 5 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



21. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for Long Body)


    B137546
  1. Disconnect the rear No.1 seat outer belt's floor anchor.

    1. Remove the anchor cover.

    2. Remove the bolt and disconnect the floor anchor.



    B129706
  1. Remove the 2 screws and 2 bolts.

  1. Using a screwdriver, detach the 5 claws.

    HINT:
    Tape the screwdriver tip before use.

  1. Using a clip remover, detach the 4 clips and remove the trim board.

  1. Disconnect the power outlet socket connector.

  1. Remove the belt hanger.



22. REMOVE AIRBAG SENSOR REAR LH


B127923E01
  1. Disconnect the connector.

  1. Remove the bolt and airbag sensor.