SEAT POSITION SENSOR > REMOVAL |
| 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 2. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat) |
![]() |
Remove the 2 bolts on the rear side of the seat.
Lift up the seat track adjusting handle and move the seat to the rearmost position.
![]() |
Remove the 2 bolts on the front side of the seat.
Lift up the seat track adjusting handle and move the seat to the center position. Also, operate the reclining adjuster release handle and move the seatback to the upright position.
Disconnect the connector under the seat.
Remove the seat.
| 3. REMOVE FRONT SEAT ASSEMBLY (for Power Seat) |
Operate the power seat switch knob and move the seat to the foremost position.
![]() |
Using a screwdriver, detach the 2 claws.
Remove the front seat track bracket outer cover in the direction indicated by the arrow in the illustration.
![]() |
Using a screwdriver, detach the 2 claws.
Remove the front seat track bracket inner cover in the direction indicated by the arrow in the illustration.
![]() |
Remove the 2 bolts on the rear side of the seat.
![]() |
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front side of the seat.
Operate the power seat switch knob and move the seat to the center position. Then, operate the power seat switch knob and move the seatback to the upright position.
Disconnect the cable from the negative (-) battery terminal.
Disconnect the connectors under the seat.
Remove the seat.
| 4. REMOVE SEAT SLIDE POSITION SENSOR PROTECTOR |
| 5. REMOVE SEAT POSITION AIRBAG SENSOR |
![]() |
Remove the seat slide position sensor protector from the seat position sensor.
Using a T30 "torx" socket, remove the "torx" screw and seat position sensor.
Disconnect the connector.