Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedures listed below are for the LH side.



1. REMOVE REAR DISC BRAKE PAD
  1. Remove the 2 disc brake pads.



2. REMOVE ANTI-SQUEAL SHIM
  1. Remove the shims from each pad.



3. REMOVE PAD WEAR INDICATOR PLATE
  1. Remove the indicator plates from the pads.



4. REMOVE REAR DISC BRAKE PAD SUPPORT PLATE
  1. Remove the 2 plates from the brake cylinder mounting.



5. REMOVE REAR DISC BRAKE CYLINDER MOUNTING LH


    C127287
  1. Remove the 2 bolts and cylinder mounting.



6. REMOVE REAR DISC BRAKE CYLINDER SLIDE PIN


    C127298
  1. Remove the 2 pins (upper and lower) from the mounting.



7. REMOVE REAR DISC BRAKE CYLINDER SLIDE BUSH


    C127071E02
  1. Using a screwdriver, remove the slide bush from the slide pin (lower).

    NOTICE:
    Be careful not to damage the pin.

    HINT:
    Tape the screwdriver tip before use.



8. REMOVE REAR DISC BRAKE BUSH DUST BOOT


    C127299
  1. Remove the 2 boots from the mounting.



9. REMOVE CYLINDER BOOT


    C127288E01
  1. Using a screwdriver, pry out the set ring and boot.

    NOTICE:
    Be careful not to damage the brake piston and cylinder.

    HINT:
    Tap the screwdriver tip before use.



10. REMOVE REAR DISC BRAKE PISTON


    G033449E02
  1. Place a piece of cloth between the piston and disc brake cylinder.

  1. Apply compressed air to remove the piston from the disc brake cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when applying compressed air.

    NOTICE:
    Be careful not to spatter the brake fluid.



11. REMOVE PISTON SEAL


    C127290E01
  1. Using a screwdriver, pry out the seal from the cylinder.

    NOTICE:
    Be careful not to damage the inner cylinder and piston seal groove.

    HINT:
    Tap the screwdriver tip before use.



12. REMOVE REAR DISC BRAKE BLEEDER PLUG
  1. Remove the bleeder plug cap and bleeder plug from the cylinder.



13. REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
  1. Remove the shoe adjusting hole plug from the rear disc.



14. REMOVE REAR DISC


    C129072E01
  1. Put matchmarks on the disc and axle hub.

  1. Release the parking brake.



    C127304
  1. Turn the shoe adjuster until the disc turns freely, and then remove the disc.

  1. Install the shoe adjusting hole plug to the rear disc.